By A Mystery Man Writer
Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin
First Layer Issues : r/FixMyPrint
First Layer Issues - Troubleshooting - V1 Engineering Forum
Well, I'm getting started! - Troubleshooting - V1 Engineering Forum
Problem with 1st layer after changing layer height – Assembly and
First Print - Troubleshooting - V1 Engineering Forum
first layer problems after upgrade to MK3S – Assembly and first
First Layer Issues - Troubleshooting - V1 Engineering Forum
Irregular first layer problem – How do I print this? (Printing
Myriad of First Layer Issues {MK3S+} : r/prusa
First Layer Issues - Troubleshooting - V1 Engineering Forum
First layer issues – Assembly and first prints troubleshooting
First layer issues with intricate patterns – Assembly and first
First Layer Problems – Assembly and first prints troubleshooting
Any idea what causes this pilling and mess on the first layer